Sony LMD-2451MD Gebrauchsanweisung Seite 70

Submenu
LANGUAGE
POWER SAVING
I/P MODE (picture delay
minimum)
BACKGROUND
70
Adjustment Using the Menus
Setting
Selects the menu or message
language from among seven
languages.
• ENGLISH: English
• FRANÇAIS: French
• DEUTSCH: German
• ESPAÑOL: Spanish
• ITALIANO: Italian
• : Japanese
• : Chinese
Sets the power saving mode on or
off. When you set to ON, the
monitor goes into power saving
mode if no signal is input for about
one minute.
Selects to set the delay by the
picture processing to the minimum
level when the interlace signal is
input.
*1
• INTER-FIELD : Mode for
giving precedence to the
picture quality. Performs
interpolation depending on
the movement of the images
between the fields. It takes
longer than "FIELD
MERGE" or "LINE
DOUBLER" for processing
the picture. "INTER-
FIELD" is the factory
setting.
*2
• FIELD MERGE : The
processing time is shorter.
Combines the lines in the
odd fields and even fields
alternately regardless of the
movement of images.
Suitable for viewing still
images.
• LINE DOUBLER: The
processing time is shorter.
Performs interpolation by
repeating each line in the
data receiving sequence
regardless of the field. As
the line flicker is displayed
in this mode, it is available
for checking the line flicker
of the telop work and so on.
*1
When MULTI DISPLAY
ENABLE is set to ON, INTER-
FIELD cannot be selected.
*2
When MULTI DISPLAY is set
to SIDE BY SIDE, FIELD
MERGE cannot be selected.
Sets the brightness of the black bars
appearing in the upper and lower
positions of the screen, or on the
sides of the screen.
• OFF: Displays a darker bar
(black).
• ON: Displays a brighter bar
(gray).
MULTI DISPLAY SETTING
USER CONFIG MULTI DISPLAY SETTING
M U LT I D I S P L AY E N A B L E :
M U LT I D I S P L AY:
S U B I N P U T S E L E C T :
P O S I T I O N :
F R A M E :
Submenu Setting
MULTI DISPLAY Selects ON to display the multi display
ENABLE and OFF not to display.
Notes
• When the frame frequency of the
main display is different from that of
the sub display, the picture may be
disturbed.
When no signal is input to the main
display, the picture may not be
displayed correctly.
• When you set SUB INPUT SELECT
to OFF, MULTI DISPLAY ENABLE
is set to OFF automatically.
• When MULTI DISPLAY ENABLE is
set to ON, APA (page 71) is not
available.
MULTI DISPLAY • POP: The sub display is put by the
side of the main display. Either
NORMAL or OVER can be
selected for the scan mode in the
main display.
• SIDE BY SIDE: The main display is
put in the left side of the display
and the sub display is put in the
right side of the display. Either
NORMAL or FULL can be
selected for the scan mode in the
main and sub display. The scan
mode of the main and sub display
will change at the same time. You
cannot set a different scan mode
for each display.
To switch the scan mode, press the
function button assigned to change the
scan mode. See "FUNCTION BUTTON
SETTING" (page 71) and "About the
function assigned to the function button"
(page 71).
Note
When MULTI DISPLAY is set to SIDE
BY SIDE, CTI (page 68) is not
available.
xxx
xxx
xxx
x
x