Reception Of The Machine; Unpacking - OEM FX series Gebrauchs- Und Instandhaltungshandbuch

FX / RVE
Transport and unpacking

2.3 - RECEPTION OF THE MACHINE

Upon reception of the machine make sure that the
packing is complete and not damaged. Should the
packing be complete, remove it as specify at point 2.4
(unless otherwise instructed by the manufacturer).
Check if the instruction booklet is inside the packing as
well as the components specified in the transport
documentation.
In case any damage or defect is found:
a- Inform immediately the transport company and your
agent, both by phone and by registered letter with
return receipt;
b- Inform the manufacturer as mentioned above,
addressing the correspondence to:
OEM - ALI S.p.A.
46012 BOZZOLO (MN) Italia
Viale Lombardia, 33
Tel. 0376- 910511
Fax 0376 - 920754
2.4 - UNPACKING (Fig. 3)
To remove the packing from the machine proceed as
follows:
• Cut the straps (1) that tie up the carton.
• Open the carton (2), by removing the metallic clips.
• Remove the cardboard packaging (2).
• Check if everything is complete.
• Check if the delivery is complying with the PACKING
LIST.
ATTENTION
All packing materials should be collected and sent
to the special recovery centres for a correct
recycling.
Any damage or defect or non conformity with the
packing list should be immediately reported and, in
any case, it should be notified within 8 days from
the date of reception of the machine. On the contrary
the goods are to be considered as accepted.
IMPORTANT
FIG. 3
2
1
1
GB - 9