In Case Of Difficulty; The Hydromassage Does Not Start; The Hydromassage Stops By Itself - Jacuzzi J-Sha MI Bedienung Und Wartung

In the event of difficulty...

THE HYDROMASSAGE DOES NOT START

❱❱
First of all, check that the main switch on the power supply
line of the tub is on and that there is not a power outage. Also
make sure you have complied with the instructions provided in
the relative chapter. Make sure the remote control is pointed at
the receiver when confirming function start-up.
If there are any other irregularities, please refer to the following
instructions.
■
Defects concerning the electronics box
• Pump does not start
• The LED for the key on the receiver flashes.
• Aim the remote control at the receiver and hold down the
key for about four seconds. The display will show the
screenshot as indicated.
❱❱
Contact a Jacuzzi ® service centre .
To return to normal remote control display, press any key.
■
Insufficient water level
• The water in the tub is below the required level and the pump
is stopped.
• The LED for the
• Aim the remote control at the receiver and hold down the
key for about four seconds. The display will show the
screenshot as indicated.
❱❱
You will need to add the required amount of water and re-
peat the steps described in the chapter on the hydromassage.
Make sure you turn the remote control off and then back on.
■
Incorrect position of distributor valve
During selection of the various hydromassage cycles, if this
valve is incorrectly positioned, the cycle will not proceed.
• You will not be able to select the desired type of hydromas-
sage and the display will continue to show "Waiting Posi-
tion".
• The LED for the
• Aim the remote control at the receiver and hold down the
key for about four seconds. The display will show the mes-
sage "ERROR POSITION" as in the figure.
❱❱
Contact a Jacuzzi

THE HYDROMASSAGE STOPS BY ITSELF

❱❱
First of all, check that the main switch on the power supply
line of the tub is on and that there is not a power outage. Also
make sure you have complied with the instruction provided in
the relative chapter.
Each hydromassage cycle has its own duration. At the end
of that period, the hydromassage shuts down automatically.
Refer to the relative chapter to re-start it.
If there are any other irregularities, please refer to the following
instructions.
109
key on the receiver flashes.
key on the receiver flashes.
® service centre .