Self Clean Operation; Auto Restart Function; Tips For Effective Operation - Mitsubishi Heavy Industries SRK20ZMX-S Anwenderhandbuch

SELF CLEAN operation

■ CLEAN operation should be run after AUTO, COOL and DRY operation to remove the moisture from inside the indoor unit and control
the growth of mold and bacteria.

Auto restart function

■ What is auto restart function?
• Auto restart function records the operational status of the air-conditioner immediately prior to be switched off by a power cut, and then
automatically resumes operations after the power has been restored.
• The following settings will be cancelled:
1 Timer settings
2 HIGH POWER operations
NOTE
• Auto restart function is set at on when the air-conditioner is shipped from the factory. Consult with your dealer if this function needs
to be switched off.
• When power failure occurs, the timer setting is cancelled. Once power is resumed, set the timer again.

Tips for effective operation

■ Please observe the following for the most economic and comfortable use of your unit.
Set a suitable room temperature.
Excessively high or low temperatures
are not good for your health and waste of
electricity.
Adjust the airflow direction properly.
Adjust the up/down and left/right airflow
to ensure a steady room temperature.
1
In order to active CLEAN operation, press the CLEAN
switch with the tip of a ballpoint pen.
Every time the CLEAN switch is pressed, the display is
switched in the order of:
(CLEAN on)
NOTE
• Two hours later, the air conditioner stops running automatically. To stop
the air conditioner immediately, press the ON/OFF button.
• CLEAN operation is not operated after HEAT and FAN, OFF-TIMER,
SLEEP and ALLERGEN CLEAR operations have finished.
• The indoor unit fan runs for about two hours in CLEAN operation.
• The RUN light illuminates during CLEAN operation.
• Pressing the SLEEP button, ALLERGEN CLEAR button or NIGHT
SETBACK button during CLEAN operation cancels the CLEAN
operation and then the unit is set to SLEEP, ALLERGEN CLEAR or
NIGHT SETBACK operation.
• This is not a function for removing mold, germs or grime that have
already adhered to the unit.
Clean the filters frequently.
Clogged filters may block the airflow and
cause less efficient operation.
Operate the unit only when needed.
Use the timer properly to operate the unit
only when needed.
– 22 –
No display
(CLEAN off)
3 sec.
ON
OFF
1 sec.
Avoid direct sunlight and draught.
Cut out direct sunlight by drawing the
curtains or blinds when cooling. Keep
windows and doors shut, except when
ventilating.
Keep heat source away when cooling.
Keep heat sources out of the room as
much as possible.