Set-Up/Fitting To The Wall - Nevadent NAZ 2.4 C3 Bedienungsanleitung

CAUTION – PROPERTY DAMAGE!
The appliance may only be recharged with the supplied
►
charger.
Otherwise, the appliance could be irreparably damaged!
Operate the appliance only with the original accessories
►
supplied.
Set-up/fitting to the wall
NOTE
In damp rooms, especially in the vicinity of water (bath), the charger
be set up so that it cannot accidentally fall into the water.
Place the charger
Ensure the charger
You can also fit the charger permanently to the wall:
1) Mark two drill holes on the wall at a distance of approx. 44 mm from each
other. Check to ensure that there is a mains power socket in the immediate
vicinity.
2) Before drilling the holes, check to ensure that there are no electrical cables or
water pipes behind the markings.
3) Use a 5 mm drill bit to drill the marked holes and push the supplied wall
plugs
4) Screw in the screws
the charger
that the screws
the wall. You can adjust the distance to the wall and compensate for any
unevenness in the wall by screwing or unscrewing the screws.
5) Hang the charger
6) Ensure that the power cable is not trapped and that it lies properly in the
cut-out.
NAZ 2.4 C3
on a clean and level surface.
cannot fall into water, such as a bath or sink.
in.
so that the heads protrude a few millimetres. Hang
with the drill holes
slide into the slots. The charger
on the screws .
over the two screws
should lie flush against
GB │ IE
must
and ensure
│
19 ■