Instructions For Correct Use, Safety Instructions - Brill Hattrick 40 BHR Gebrauchsanweisung

Fault
Motor does not start.
GB
Motor starts for a short time
then suddenly stops with a loud
bang.
Aerator roller is not operating
with the blade.
Lawn turning yellow,
cut not clean.
Mower leaves deep tracks.
Wheel drive not functioning.

11. Instructions for correct use, safety instructions

Check each time you use
A
the equipment
Inspect the equipment each time
before you use it. Do not use
the equipment if safety devices
(switch handle, safety covers)
and / or if the cutting device is
damaged or worn.
Never disable safety devices.
Always carry out a visual
inspection before use in order
to determine whether the cut-
ting tool is worn or damaged
and that no screws are loose.
Check the work area before
starting work. Remove any for-
eign bodies present (e. g. stones,
branches or bones). Check for
foreign bodies whilst working.
Always wear sturdy footwear
and long trousers when working
with the appliance. Do not use
it when barefooted or only
wearing light sandals.
24
Possible Cause
Spark plug defective or
fuel tank empty.
Cylinders, pistons and bearing
of crankshaft have seized.
No motor oil in crankcase.
Rotary switch at 0 position.
V-belt torn.
Blade is too blunt,
cutting height too low.
Ground softened by water,
lawn too wet.
Drive belt broken.
Clutch cable stretched.
Warning! petrol is extremely
inflammable.
Only keep petrol in the container
provided for the purpose.
Always fill the tank outdoors
and do not smoke when filling
the tank with petrol.
Fill up with petrol before starting
the engine.
Stop the engine before topping
up.
Never open the tank cap or top
up with petrol whilst the engine
is running or the equipment is
hot.
For safety reasons, do not attempt
to start the engine if the petrol
has overflowed. Instead, remove
the equipment from the area
contaminated with petrol. Doe not
make any attempt whatsoever to
start the engine until all the
petrol vapours have evaporated.
Remedy
Clean spark plug and / or
fill the fuel tank.
Motor overhaul at specialist
workshop required.
Turn rotary switch to 1 with the
motor switched off.
V-belt must be replaced by
specialist workshop.
Change blade and / or use
a slightly higher cutting height.
Allow lawn to dry,
do not mow if grass is wet.
Drive belt is to be replaced.
Obtain assistance from
a Brill Service Station.
Readjust the clutch cable.
For safety reasons, the petrol
tank and tank cap must be
replaced if damaged.
Always replace damaged
exhaust components.
Check the cutting tools regularly
for damage and have them
repaired correctly if necessary.
Only have cutting tools replaced
by Brill Service or your
authorised specialist dealer.
Use /
A
Responsibility
Warning! The safety
A
devices installed on the
appliance by the manufacturer
are neither to be removed nor
bypassed as this can result in
injury.
Make sure that there are no
other people (especially children)
or animals within or near the
working area.