Technical Specifications; Troubleshooting - GBS Jolly line 43000 Betriebsanleitung

Technical specifications

General:
1. Frequency: 5.725 GHz – 5.875 GHz
2. Channels: 7 selectable channels
3. Antenna: Planar array
4. IR remote frequency 433.92 MHz
5. IR carrier frequency 32 ~ 57 kHz
6. I/O jack 3.5 mm RCA AV conn.
7. Power supply 9V DC adaptor
8. Dimensions 110 x 65 x 30 mm
-------------------------------------------------------------
Transmitter:
1. Supply current 140 mA ±10 mA
2. Output power 13 dBm ± 1 dB ( CE )
0 dBm ± 1 dB ( FCC )
IR extender receiver
Reception sensitivity -95 dBm, min
IR LED operative range 2 meters (min.)
External IR LED jack 2.5 mm mono plug
-------------------------------------------------------------
Receiver:
1. Supply current 230 mA ± 20 mA
2. Input sensitivity -85 dBm (typ.)
3. Video output 1 V (typ.) (± 0.2 V)
P-P
IR extender transmitter
RF output power 8 dBm ± 2 dB (CE)
0 dBm ± 2 dB (FCC)
Sensor operative range 5 meters (min.)

Troubleshooting

Read this information before attempting to resolve
any operating problems.
If you are unable to resolve the problem with the
information presented here, contact your dealer or
the nearest technical assistance center.
Do not attempt to repair the device under any
circumstances, as this would invalidate the warranty.
PROBLEM POSSIBLE CAUSE
No The transmission Set the transmission
transmission channels of the channel on the
of pictures or transmitter/receiver do transmitter/receiver.
sounds not correspond.
The transmission Reduce the distance (do
distance exceeds the not exceed 3 walls or 100
maximum. meters).
Connection cable. Check the cable
connector and the RCA
connector (different for
transmitter and receiver).
Transmitter or receiver Switch on the transmitter
not switched on. or the receiver.
Incorrect direction of Orient the antenna in the
the planar antenna. correct position.
Low image or Interference. Move the transmitter or
sound quality receiver a few
centimeters (do not
exceed 3 walls or 100
meters).
Change the transmission
channel on the
transmitter/receiver.
Presence of microwave Look for a channel with
or computer devices or better reception.
telephones with
Bluetooth or wireless
functions.
Infrared module. Check the connection
and the position of the
infrared module.
The remote A wireless transmitter in Switch off the device that
control does the 433 MHz frequency is causing interference.
not work band (e.g. a baby
phone) interferes with
the transmission.
Maximum distance Reduce the distance of
exceeded. the transmitter/receiver to
less than 70 meters.
CE 0560
DOZ0000-0xxx
REMEDY