Channel Selection; Package Contents - GBS Jolly line 43000 Betriebsanleitung

43000-User Guide
5.8 GHz mini AV-Sender

Package contents

A. User Guide
B. Transmitter (Tx) and Receiver (Rx)
C. 2 x 9V DC Power Supply
D. 2 x AV cable: 3.5mm-SCART
E. IR cable
SIDE:
Channel Selector 2
FRONT:
Tx: IR LED
Rx: IR sensor
REAR:
A/V cable jack ON/OFF
Transmitter REAR:
A/V cable jack
Channel Selector 1
Antenna:
Transmitter
On/off indicator
(The Tx and Rx antennas must face one another for the
best reception.)
Power supply (9V)
ON/OFF Power supply
IR cable jack (9V)
Applications
Front
Receiver

Channel selection

1. There are two channel selectors as shown below
– Channel selector 1 and Channel selector 2:
Channel selector 1
2. Use Channel selector 1 to select one of the two
groups of channels: (1,3,5,7) or (2,4,6).
3. Use Channel selector 2 to select the desired
channel.
IR sensor positioning for remote control use
1. Plug the IR cable connector into the
appropriate jack on the back of the transmitter
(Tx).
2. Locate the IR sensor on the transmitting AV
device that you wish to control. If you can't find it,
consult the device's user guide.
3. Bring the external IR sensor of the cable to the
IR sensor of the transmitting AV device and
secure it with the supplied adhesive tape.
4. Position the receiver (Rx) so that the IR sensor
is directed toward the operator, in such a way that
it is easy to point the remote control at it.
Channel selector 2