Setting The Attenuation Level Of The Audio Input (Utx-B1 Only); Resetting The Accumulated Battery Use Time Indication (Utx-B1 Only) - Sony UWP-X5 Bedienungsanleitung

Setting the attenuation
level of the audio input
(UTX-B1 only)
The attenuation level can be set during
signal transmission.
1
Do the following while there is
no signal transmission.
Turn on the transmitter while pressing
down the SET button, and press the
SET button repeatedly until the
attenuation level indication appears in
the display section.
Do the following while there is
signal transmission.
Press the SET button repeatedly until
the attenuation level indication appears
in the display section.
2
Press the + or – button to select the
attenuation level.
The selectable range is from 0 dB to 21
dB in steps of 3 dB (the factory setting
is 0 dB).
3
Do the following while there
is no signal transmission.
Set the POWER switch to OFF to
complete the setting, or press the SET
button to set other items.
The results are stored in memory.
The change becomes effective the next
time you turn on the transmitter by
setting the POWER switch to ON.
Resetting the accumulated
battery use time indication
(UTX-B1 only)
The accumulated battery use time is the
total time (in hours and minutes) that the
batteries have been used. It is recorded
whenever the transmitter is on.
Reset the indication to "00:00" whenever
you replace the batteries.
1
Turn on the unit while pressing down
the SET button.
Keep pressing the SET button until the
display section parameters start to
flash.
2
Press the SET button repeatedly until
the accumulated time indication
appears in the display section.
3
Press the – button.
The time indication resets to "00:00."
While "00:00" is still displayed, you
can return to previous value by
pressing the + button.
4
Set the POWER switch to OFF to
complete the setting, or press the SET
button to set other items.
The results are stored in memory.
The change becomes effective the next
time you turn on the unit by setting the
POWER switch to ON.
Settings 25