Settings; Setting The Transmission Channel (Utx-B1 Only) - Sony UWP-X5 Bedienungsanleitung

Settings

Setting the transmission
channel (UTX-B1 only)
Refer to the supplied leaflet "Sony Wireless
Microphone System Frequency List" for details on
the selectable channel groups and channels.
1
Turn on the transmitter while pressing
down the SET button.
Keep pressing the SET button until the
display section parameters that were
displayed when the unit was last turned
off start to flash.
2
Press the SET button repeatedly until
the channel number (or frequency)
indication appears.
3
Press the + or – button to select the
channel number (or frequency).
Pressing the + button cycles the
indication in the order shown in the
tables in the supplied leaflet "Sony
Wireless Microphone System
Frequency List."
Pressing the – button cycles the
indications in the opposite direction.
Hold down the + or – button to change
the channel number (or frequency)
faster.
Notes on the European model
Select the group number before
selecting the channel number as
follows.
1) While the left two digits are
flashing, select the group number
by pressing the + or – button.
2) While the desired group number
appears, press the SET button.
22 Settings
The right four digits start to flash to
allow the selection of the channel
number.
3) Select the channel number by
pressing the + or – button.
Group
Channel
selection
selection
V: + button
Group, channel, and frequency
selection examples for CE62 model
are shown.
4
When the desired channel number (or
frequency) appears, set the POWER
switch to OFF to complete the setting,
or press the SET button to set other
items.
The results are stored in memory. The
stored channel number (or frequency)
will appear in the display section the
next time you turn on the transmitter
by setting the POWER switch to ON.
Notes
• When you are setting the transmission
channel, the transmitter cannot be used to
transmit signals.
• Do not remove the batteries while setting
the transmission channel. If they are
inadvertently removed, re-insert them
immediately and redo the procedure
"Setting the transmission channel (UTX-
B1 only)" from step 1.
• Make sure that the selected channel is the
same on the transmitter and tuner being
used in the same system.
• If you turn off the transmitter and then
immediately turn it on right after setting
Frequency
selection
v: – button