Preparing The Product For Use - Videotec DTWRX Bedienungsanleitung

4 Identification
4.1 Product description and type
designation
The DTWRX receiver is an optional board for remote
control of wiper and washer pump. It works only
with WASPT pump series, where it can be easily
installed thanks to its connector. It allows the control
of wiper and washer functions when the housing is
stand-alone, not mounted on a P&T and then without
telemetry receiver.
4.2 Product markings
See the label attached to the outside of the package.
2
5 Preparing the product for
use
Any change that is not expressly approved
by the manufacturer will invalidate the
guarantee.
5.1 Unpacking and contents
5.1.1 Unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
5.1.2 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Data receiver board
• Instructions manual
5.2 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.