Symbols On The Machine; Keyswitch; Labels; Emergency Stop Switch - Primus F22 Bedienungsanleitung

WARNING: Original or identical parts must be used for replacement in this washer extractor. After
servicing replace and secure all panels in the original way. Take these measures for continued
protection against electrical shock, injury, fire and/or property damage.

3. SYMBOLS ON THE MACHINE

Caution, dangerous electrical tension,
electrical devices
Caution, other danger, read and follow
written instructions
Caution - Increased temperature
In case of emergency, press the
EMERGENCY button to stop the machine
Do not put your hands to the marked area
Push to open the door
Press to unblock the door
Do not close or cover
Transfer of heat in general

3.1.1.KEYSWITCH

The keyswitch can be mounted on the front panel, the rear panel or inside the machine.
With the keyswitch you can select „Run mode" or „Program mode"
RUN MODE : This is the Normal wash machine operation.
-
PROGRAM MODE : Only for changing the wash programs and machines settings.
-

3.1.2.LABELS

On the labels you can find Instructions for the Washing machine
Operation and Information about the Wash Programs.

3.1.3.EMERGENCY STOP SWITCH

This emergency stop switch is only used by not coin washer-extractors
6
Always disconnect the washer from the electrical supply before
attempting any service. The washer extractor is out of tension if
the main plug is taken out or when the main supply is
disconnected.
Caution!
Extreme hot conditions can arise in the surroundings of this air.
Watch out for vapor that escapes from the washer extractor
venting !
Caution!
Do not cover the washer extractor venting. It serves as a vapor
outlet to prevent pressure building in the washer extractor
USER´S MANUAL
The machine hot air outlet
Machine under current
Machine in operation (only for
"Full Control")
Heating
Position of change-over switch
for washing soaps adding for the
hoppers
Position of change-over switch
for liquid soaps adding by
external pumps
The machine is switched over to
programming regime (only for
"Full Control")
PUB DATE: 05/00 507 329