Change In The Door Hinging - Amica FM061.3 Gebrauchsanweisung

This bar refrigerator has the door hinges on the right. If you wish to change the opening
direction, follow the instructions below:
1 Remove the upper hinge cover (6) first
2 Remove the two screws (1) that hold the upper hinge (5) (right side) to the frame.
Take away the upper hinge (5).
3 Lift the door and place it on a padded surface to prevent scratching.
4 Remove the two screws (8) that hold the lower hinge (2), remove the lower
hinge (2).
5 Remove the left front leg (4) and transfer it to the right side.
6 Remove the hole cover plate (7) on the right side.
7 Install the lower hinge (2) onto the left side of the lower frame with the two screws
through the opposite two holes (8).
8 Set the door in its place making sure it rests on the door seat at the lower hinge (2).
9 While holding the door in the closed position secure the upper hinge (5) on the top
left hand side with the two screws (1) through the opposite two holes. Do not tighten
the two screws (1) until the top of the door is levelled with the counter top.
10 Install the upper hinge cover (6) on the upper hinge.
CHANGE OF THE DOOR HINGING
46