Herunterladen Inhalt Inhalt Diese Seite drucken

Information On Using Batteries; Initial Operation - Kompernass TA 120 A2 Bedienungsanleitung

Alarm-türstopper
Vorschau ausblenden Andere Handbücher für TA 120 A2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Do not make any unauthorised modifications or
alterations to the device .
Repairs to the device during the warranty period
may only be carried out by a customer service
department authorised by the manufacturer .
Otherwise no additional warranty claims can be
considered for subsequent damage .
Do not place the device in locations that are subject
to direct sunlight, as this could lead to overheating
and cause irreparable damage .
Protect the device from moisture and liquid penetra-
tion . Do not place any liquid-filled vessels (such as
flower vases) on the device .

Information on using batteries

DANGER
Mishandling the batteries can cause fires,
explosions, leakages or other hazards!
Do not throw the batteries into the fire .
Do not short-circuit the batteries .
Do not attempt to recharge the batteries .
Check the condition of the batteries regularly .
Leaking battery acid can cause permanent
damage to the appliance .
Special care should be taken when handling
damaged or leaking batteries . Risk of acid
burns! Wear protective gloves .
Store batteries in a place that is inaccessible to
children . If a battery is swallowed, seek medical
attention IMMEDIATELY .
If you do not intend to use the appliance for
a long time, remove the batteries .

Initial operation

Slide the on/off switch to the "OFF" position .
Unscrew the battery compartment beneath the
device and connect the 9 V block battery .
Insert the battery into the device and screw the
battery compartment closed again .
Then perform a function test . First cover up the
siren with your hand or a cloth to avoid damage to
your hearing .
Move the On/Off switch to "ON" and push down
the metal plate of the door stopper until the alarm
goes off . The alarm can be interrupted at any time
by moving the On/Off switch to the "OFF" position .
NOTE
If the red LED illuminates with the switch in the
"ON" position, the battery must be replaced
with a new one of the same type .
GB │ IE │ NI
3
 ■

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis