Installation; Operation - Silvercrest SKM 350 A1 Bedienungsanleitung

__CPE273409_Kuechenmaschine_B8.book Seite 21 Dienstag, 17. November 2015 11:58 11

6. Installation

DANGER! Risk of injury from
cutting!
~ The blade insert|8, the grating disk|5
and slicing insert|4 are sharp. Handle
with care.
~ Only plug the mains plug|14 into the
wall socket after the food processor has
been completely assembled.
NOTE:
• The device is equipped with a safety
switch. The bowl|11 can only be
locked with a closed lid|3 and can only
be put into operation once it's locked.
1. Figure A: place the bowl|11 on the mo-
tor block|15. The symbol
the bottom marking on the bowl|12. Do
not turn the bowl.
2. Place the drive axle|9 in the bowl.
3. Figure E: if required, place the slicing
insert|4 / grating disk|5 into the insert
holder|6.
4. Place the dough blade|7, the blade in-
sert|8 or the insert holder|6 with at-
tached slicing insert|4 / grating disk|5
on the drive axle|9.
5. Dough blade|7 / Blade insert|8: Fill the
prepared foodstuffs into the bowl|11,
as desired.
6. Figure A+B: place the lid|3 on the
bowl|11. The symbol
top marking on the bowl|10.
7. Figure B+C: turn the lid|3 in a clock-
wise direction as far as it will go, until
the symbol |2 points to the top mark-
ing on the bowl|10.
8. Figures C+D: turn the bowl|11 in a
clockwise direction as far as it will go,
until the symbol
tom marking on the bowl|12.
9. Insert the mains plug|14 into a wall sock-
et corresponding to the technical data.

7. Operation

~ The insert holder|6, the blade insert|8
~ The device must never be operated with-
WARNING! Risk of material dam-
age!
~ In order to prevent damage to the de-
|16 points to
CAUTION:
~ Depending on the hardness and consist-
|2 points to the
NOTE:
• For chopping harder foodstuffs, use the
|16 points to the bot-
DANGER! Risk of injury from
cutting!
and the dough blade|7 keep on turning
after the device has been turned off.
Please wait until all parts have come to
a standstill before unlocking the
bowl|11 and opening the lid|3.
out the bowl|11.
vice, interrupt the blending process im-
mediately if the insert holder|6, the
blade insert|8 and the dough blade|7
are not turning or are turning with diffi-
culty. If this happens, pull out the mains
plug|14 and check whether there is
something in the bowl|11 blocking
movement or whether the food is too
tough. Also check whether the device is
assembled correctly.
ency of the foodstuffs, do not fill the
bowl|11 to the maximum, as the insert
holder|6, the blade insert|8 and the
dough blade|7 could get blocked. Pay
attention here to the guideline values for
various foods in the Processing table
section.
setting P. Work with short pulses
(1 pulse: turn on P for approx. 1 sec-
ond). The number and length of the puls-
es will depend on the quantity and
consistency of the food.
21
GB