Contents Of Carton; Installation; Installation Considerations; Mounting Locations - Rockford Fosgate RFX series Einbau Und Betrieb

C C
ONTENTS OF ARTON
Model RFX 8620M 6 CD Changer
Installation & Operation Manual
(1) 6 CD Disc Magazine
(2) Mounting Brackets
I
NSTALLATION

INSTALLATION CONSIDERATIONS

The following is a list of tools needed for installation:
Battery post wrench
This section focuses on some of the vehicle considerations for installing your new unit. Pre-planning
your system layout and best wiring routes will save installation time. When deciding on the layout
of your new system, be sure that each component will be easily accessible for making adjustments.
CAUTION: If you feel unsure about installing this system yourself, have it installed
!
by a qualified technician.
CAUTION: Before installation, disconnect the battery negative (-) terminal to
!
prevent damage to the unit, fire and/or possible injury.
Before beginning any installation, follow these simple rules:
1. Be sure to carefully read and understand the instructions before attempting to install the Unit.
2. For safety, disconnect the negative lead from the battery prior to beginning the installation.
3. For easier assembly, we suggest you run all wires prior to mounting your unit in place.
4. Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic
lines, vacuum lines or electrical wiring when working on any vehicle.
5. Never run wires underneath the vehicle. Running the wires inside the vehicle provides the best
protection.
6. Avoid running wires over or through sharp edges. Use rubber or plastic grommets to protect any
wires routed through metal, especially the firewall.

MOUNTING LOCATIONS

The unit can be installed in a wide range of operating locations. However, care should be taken to
ensure optimum performance.
Engine Compartment
Never mount this unit in the engine compartment. Mounting the unit in the engine compartment
will void your warranty.
Trunk Compartment
This is the preferred place to mount the unit. This unit can be mounted in a variety of positions.
Always ensure the location allows you easy access and allows the CD magazine to eject fully, be
removed and reinstalled. Use the following precations when installing in a vehicle trunk;
• Ensure there is no fuel tank, wiring or piping on the other side of the mounting surface.
• Ensure the installation of the unit will not hinder the movement of the trunk lid or interfere with
the spare tire, etc.
• Use only the supplied mounting kit for a safe and proper installation.
4
(2) Plate Brackets
Hardware Package
(1) 8-pin DIN cable
Hand held drill w/assorted bits