Taurus PRIOR GLASS Gebrauchsanweisung Seite 12

and, once the fan has been switched on,
progressively increase the speed to the desired
position.
ELECTRONIC SPEED CONTROL:
- The speed of the appliance can be regulated
by using the speed regulator control (H). This
function is very useful, as it makes it possible to
adapt the speed of the appliance to the type of
work that needs to be done.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Unplug the appliance from the mains.
- Lift the jar from the motor body.
- Clean the appliance.
"TURBO / ICE CRUSH" FUNCTION
- The appliance works in highest speed to achie-
ve optimal performance.
- Press this button to operate and release the
button when you wish to stop operating.
- This function gives optimal result for ice-crus-
hing, up to desired snowy level.
- We recommend working by pressing the button
in cycles of 3 seconds and repeating the opera-
tion until you obtain the desired result.
- To crush ice cubes, put no more than 4 ice cu-
bes at one time. If you wish to add more ice, pull
out the measuring cup and insert the ice cubes
consecutively.
PRIOR MILL - MILL:
- Open the lid by turning it in clockwise direction.
- Put the ingredient into the grinder bowl (only dry
ingredients). Do not overfill the bowl.
- Turn the mill unit clockwise until the lock clicks
into place. (Fig.2).
- Connect the appliance to the mains.
- Choose desired speed to start grinding.
ONCE YOU HAVE FINISHED USING THE MILL
UNIT:
- Select the "0" position at the speed selector.
- Unplug the appliance to the mains.
- Lift the mill unit from the motor body.
- Turn the lid counter clockwise to open it.
- Clean the appliance.
CABLE COMPARTMENT
- This appliance has a cable compartment situa-
ted on its underside.
- If the appliance turns itself off and does not
switch itself on again seek authorised technical
assistance.
CLEANING
- Disconnect the appliance from the mains and allow
it to cool before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- During the cleaning process, take special care
with the blades, as they are very sharp.
- If the appliance is not in good condition of clean-
liness, its surface may degrade and inexorably
affect the duration of the appliance's useful life
and could become unsafe to use.
- The following pieces may be washed in a dis-
hwasher (using a soft cleaning program):
- Jug
- Lid
- Measuring cup
- Grinder cup (*)
- Then dry all parts before its assembly and
storage.
SELF-CLEANING FUNCTION:
- Put water and a small amount of washing up
liquid in the jar.
- Select the function "turbo".
REMOVABLE BLADES FOR EFFECTIVE
CLEANING
- Loosen the blade fixing ring by turning it in cloc-
kwise direction. (Fig.3).
- Remove the blade fixing ring, blade set, sealing
ring and clean them.
- After cleaning, replace the blade set and turn
blade fixing ring in opposite direction.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be