Main Screen - Selco SABER 70 CHP Betriebsanweisung

3.4 Main Screen

Allows the control of the system and of the cutting process,
showing the main settings.
XE
XA
XP
1 Cutting process
Selects the cutting process
Selects the cutting method:
2 step (solid piece cutting)
4 step (solid piece cutting)
2 step (hollow piece cutting)
2 step (gouging)
2 Synergy
Selects material type
Carbon steels
Stainless steels
Aluminium
3 Synergy
Selects piece thickness
1÷35 mm
4 Air test button
Removes impurities from the compressed air circuit and
sets the appropriate preliminary pressure and com-
pressed air flow, without power on.
5 Measurements (Pressure gauge)
Displays the measured air pressure value for the cutting
process.
6 Torch components
Indicates the torch component to use under the select-
ed operating conditions.
Always use original spare parts.
7 Cutting parameters
7a Parameter icon
7b Parameter value
7c Parameter unit of measurement
8 XE Graphic mode
8a Piece thickness
9 XA Graphic mode
9a Piece thickness
9b Recommended cutting capacity (R)
9c Maximum cutting capacity (M)
9d Separation capacity (S)
9e Perforation capacity (P)
37