Using The Facial Sauna; Using The Infuser Function; Using The Product As A Humidifier - Silvercrest SGS 600 A1 Bedienungs- Und Sicherheitshinweise

D iscard any water remaining in the water res-
ervoir after use to prevent the growth of
2
bacteria. To do so, allow the product to cool
down, remove the water tank
product so water can drain out of the water
reservoir .
2

Using the facial sauna

Connect the mains plug to the mains socket.
S et the rotary switch
edge of the rotary switch will light up blue.
Steam will soon start coming out of the steam
chamber .
7
Note: When using this function for the first time,
first check the temperature of the steam with your
hand from a distance of about 25 cm from the
steam chamber before aiming the steam at
7
your face. If you feel the steam is too hot, increase
the distance to approx. 45 cm.
Now aim the steam at your face. Choose a dis-
tance which provides a comfortable steam tem-
perature (see Fig. G). For example you can sit on
a bar stool and place the device on a chair, etc.
CAUTION! RISK OF BURNS DUE TO HOT
SURFACES! Always keep a minimum distance
of 25 cm from the steam chamber
Note: Position your face so the steam hits your
chin first. This ensures the steam will cover your
entire face.
Note: With the tank full, the "Facial Sauna"
function will last for approx. 15 minutes.
S et the rotary switch
the product off again.
D iscard any water remaining in the water res-
ervoir after use to prevent the growth of
2
bacteria. To do so, allow the product to cool
down, remove the water tank
product so water can drain out of the water
reservoir .
2

Using the infuser function

F ill the cup with chopped fruits and / or
4
flowers. Or pour a few drops of essential oil
onto a cotton ball and add to the cup
and tip the
1
to position . The
5
.
7
to position to switch
5
and tip the
1
.
4
T urn the steam chamber
until the arrow on the steam chamber
up with the symbol
Fig. B).
R emove the steam chamber
housing (see Fig. C).
6
P lace the filled cup
P ush the steam chamber
housing (see Fig. E).
6
T urn the steam chamber
arrow on the steam chamber
the symbol
on the housing
Connect the mains plug to the mains socket.
Set the rotary switch
The edge of the rotary switch will light up blue.
Infused steam will soon start coming out of the
steam chamber .
7
Note: When using this function for the first
time, first check the temperature of the steam
with your hand from a distance of about 25 cm
to the steam chamber
steam at your face.
N ow aim the steam at your face. Choose a
distance which provides a comfortable steam
temperature (see Fig. G).
ATTENTION! RISK OF SCALDING! Always
keep a minimum distance of 25 cm from the
steam chamber .
7
Note: Position your face so the steam hits your
chin first. This ensures the steam will cover your
entire face.
S et the rotary switch
the product off again.
D iscard any water remaining in the water res-
ervoir after use to prevent the growth of
2
bacteria. To do so, allow the product to cool
down, remove the water tank
product so water can drain out of the water
reservoir .
2

Using the product as a humidifier

The product may also be used as a humidifier for
small rooms and for short periods.
Connect the mains plug to the mains socket.
S et the rotary switch
of the rotary switch will light up blue. Steam will
Set-up
counter-clockwise
7
lines
7
on the housing (see
6
from the
7
in the housing .
4 6
back into the
7
clockwise until the
7
lines up with
7
(see Fig. F).
6
to position .
5
before aiming the
7
to position to switch
5
and tip the
1
to position . The edge
5
GB/IE/NI/CY 11