Niko 10-364 Produktinformation Seite 61

8.2. Legend LED display
LED Status
green is on (during 3 s)
flashing
red is on (during 3 s)
is on (during 2 min)
flashing
orange is on
flashing
flashing
Run/Prog key is on
flashing
8.3. Legend confirmation tones
Tone
short confirmation tone
positive confirmation tone
negative confirmation tone
8.4. Programming with infrared remote control
8.4.1. Programmering starten
Power supply and control unit
Deactivate and activate programming
mode
Switch programming mode of the
installation on
EN
Symbol Indication
• transponder card recognized
G
• access granted
• programming in programming mode is possible using infrared remote
G
control or master transponder
R
• transponder card not recognized
blocking time after:
• third time a wrong master code has been entered with the infrared remote control
R
• third time a wrong master transponder has been used
• third time a wrong transponder has been used
R
• possible to delete in the programming mode via master transponder
• manual programming mode via master transponder
O
• all memory locations have been assigned
• manual programming mode via master transponder
O
• only one memory location available
• error indication when starting the device
• programming mode of the installation is switched off
• programming mode of the installation is switched on
Symbol Indication
infrared remote control confirms push of the key with a short key confirmation
tone
correct input or correct action
wrong input or wrong action
Press the RUN/PROG key briefly. The LED is flashing and you
RUN
have 5 minutes to program.
PROG
10-364
61