Searching For The Time And Date - Sony SVT-N72P Bedienungsanleitung

Searching for the Time and Date

1
1
Turn on the power of the equipment to be used.
2
Press SEARCH/AUDIO ON in stop mode until the
time/date search indicator flashes in the display
window and on the monitor screen.
When CONV. is selected for T/D SEARCH on
the GENERAL SET menu:
In the display window
When NEW is selected for T/D SEARCH on the
GENERAL SET menu:
In the display window
3 2 4
1 H 1 2 M 0 6 S
T / D S E A R C H
0 1 1 2
Hour
Date
On the monitor
1 H 1 2 M 0 6 S
T / D S E A R C H
0 1 1 2 2 0
Minute
Hour
Date
On the monitor
3
Press MENU + or – to set the date and press
MENU B to move the flashing to the time. Press +
or – to set the time. Set the minute (when NEW is
selected) on the same way.
4
Press FF M or REW m.
The cassette stops at the portion when you set the
time and date and the still picture playback is
displayed.
The time/date search mode is automatically
cleared.
Notes
• If the tape reaches its end during searching, the tape is
rewound and the unit enters the stop mode at the beginning
of the tape.
• Be sure to set T/D SEARCH on the GENERAL SET menu
to the same setting as the tape was recorded with.
Otherwise, searching for the time and date cannot be done
properly.
• You can use the T/D SEARCH only when the alarm speed
is set to 3H and the recorded section is longer than 20
seconds.
41