List Of Menus And Utility Sub Menus - VWR SAS ISO 100 Contact Bedienungsanleitung

3. Replace the aspirating head.
4. Select required volume and start the unit. The airflow is directed into the agar surface of the plate.
5. At the end of the cycle, remove the aspirating head.
6. Close and remove the plate.
7. Incubate.
8. Count the colonies, record the results on the microbiological air sampling report and read the results.

List of menus and utility sub menus

START Press to repeat the same volume of prior sampling
MENU Press to enter the following sub menus
SELECT VOLUME The volume of aspirated air can be modified according to 8 programmed values
PROGRAM VOLUME The 8 programmed values can be modified
SET DELAY The air sampler can be programmed to start sampling after a programmable delay
(1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 20, 30, 40, 50, 60 minutes)
MULTIMODE The air sampler can be programmed to extend the total sampling time using
"sequential interval time" sampling by the following sub menus:
INTERVAL TIME
Can be programmed from 1 to 59 min
NUMBERS OF RUNS
Can be programmed from 1 to 19 air aspirations
SINGLE RUN VOLUME
Can be programmed from 1 to 1999 l
TOTAL RUNS
Shows the total volume of aspirated air
CONFIGURATION You can use the SAS with eight programmable configurations
UTILIY MODE
SET TIME
To programme date and time
SITE
To identify the sampling point
IDENTIFY
To identify the operator's name
LANGUAGE
To display text in different languages
DISPLAY RECORD
To show the recorded sampling data
CLEAR RECORD
To clear the recorded sampling data
REMOTE CONTROL
To connect to a PC with an optional device
CALIBRATION
9