Visiclear™ Filter Instructions - Buffalo Filter VisiClear Bedienungsanleitung

Figure 23.
FUSES (circuit board)
Two 10 AMP fuses (8 AMP for 220/240 VisiClear™ Systems) are located on the circuit board
within the housing of the system. It electrically protects both the systems and the operator from
damage or injury. If the system is overheated or if there is an electrical surge in the electrical
system, fuses will break and the system will not operate.
When the Service light illuminates, please contact BUFFALO FILTER® Customer Service for
system service instructions.
2.2 VisiClear™ Filter Instructions
Buffalo Filter VisiClear™ P / N
VisiClear™ Filter - Multi Port Filter
Filter(s)
Particle Size, mm
Filter Life
Filter Life Indicator
NOTE: Before installing or removing any filter, be sure that the system is turned off.
Filter Installation Instructions:
The installation of the VisiClear™ Filter into the BUFFALO FILTER® VisiClear™ Surgical Smoke
Plume Evacuator(s) is quick and simple.
1. Remove the VisiClear™ Filter from the shipping box and discard any protective wrapping.
Examine all filters for damage during shipping and storage. Do not install any filter with
visible signs of structural damage.
Buffalo Filter® VisiClear™ Operator's Manual
VSI35 (also available in 2 pack and 4 pack)
4-Stage Filtration in One Casing,
(Pre-Filter, ULPA, Carbon, Post-Filter)
ULPA
0.1 to 0.2 Microns at 99.999% Efficiency
Automatic Factory Set Filter Sensor
Time Replacement
19