Led-Rear Light Sp - Crivit SP-33 Gebrauchsanleitung

Bicycle helmet SP - 33
3. adjusting the strap divider
• Open the strap divider (Fig. D)
• The strap divider must be positioned in such a way, that the straps are taut but comfor-
table. The strap divider must be below the ear, and the straps must not cover the ears.
• Close the strap divider (Fig. E)
an open strap divider can lead to slipping of the helmet in the event
of an accident and thus to a loss of protection!!!
4. adjusting the chin strap
• The chin strap (Fig. G.3) has been adjusted correctly if you feel slight pressure when
you open your mouth.
• If the chin strap (Fig. G.3) is too loose it must be pulled tight using the winding (Fig.
G.2) on the fastener (Fig. G.1).
• If the chin strap (Fig. G.3) is too tight it must be loosened also using the winding (Fig.
G.2) on the fastener (Fig. G.1).
Please note that you must always make sure that the fastener is
closed before you ride !!! (Fig. F)
Please be aware that the helmet can only protect if it fits properly.
Please try out different sizes and choose the one in which the helmet
fits comfortably and sits firmly upon your head.
5. visor
• Carefully pull out the pins on the visor from the pin holes on the helmet shell to remo-
ve the visor (Fig. H).
attention: the pin holes on the helmet can expand through excessive
use. in this case, the visor may no longer be used.
6. cleaning and care
• All chemicals, paints and stickers can seriously impair the protective effect of the
helmet.
• Only clean your helmet with lukewarm water, mild soap and a soft cloth.
• After every use, leave your helmet exposed to the air in order for it to dry.
7. Disposal
Please contact your local waste disposal company for the disposal of the helmet.
6
Safety information
• The LED rear light is not a substitute for the light equipment stipulated by the German
standard StVZO (§ 67).
• When used correctly, the LED rear light gives better visibility. The LED backlight
should not be used during rainy weather. It cannot be guaranteed to work if it gets
wet.
• Please only use the LED rear light together with this cycle helmet and always put it
onto the rotating wheel of the size-adjustment system.
• The LED rear light is only intended for personal use.
• Please make sure that, during use, the LED cannot be covered or obscured by collars,
rucksacks or movements of the head.
• The LED light can under certain circumstances come loose without this being noticed,
if it becomes caught on jackets, rucksacks or other objects.
• Please be aware that the battery of the LED light can fall out or become flat. Therefo-
re, check the light regularly for proper functioning.
• The batteries must not be exposed to excessive heat such as sunshine, fire or the like.
In the event that the batteries are
• incorrectly changed there exists the risk of explosion. Only replace the batteries with
the same or an equivalent battery type.
• Parents should ensure that their child also checks to make sure that the LED backlight
is working on a regular basis.
• The LED rear light is not suitable for use by children under 4 years of age.
• The LED rear light is not a toy and its use by children is only permitted if they are
under the supervision of adults.
• The changing of batteries must only be carried out by adults.
• If the battery leaks, avoid any contact with the skin as this can lead to skin irritation.
• Leaking batteries must be disposed of immediately
user information
1. Before the first use
• Take the tail light off the helmet (fig. J). Before the first use, remove the safety strips
from the reverse of the LED tail light. (Fig. I).

LED-rear light SP - 2

leD-rear light SP-2
7