CAME BPT TH/550 Montage- Und Gebrauchsanleitung Seite 49

Note. If the external probe is set as the main probe, the temperature it detects is shown on the display
and used as a reference for the heating/cooling system. The temperature detected by the device's
internal probe cannot be seen on the display.
Remote activation via phone
By connecting a suitable telephone interface to the terminals
possible from your phone:
1. Remote activation of the timed manual program: to activate this program, the input
(terminals
WARNING. The timed manual program can be disabled in advance by closing the input (terminals
) for a minimum of 2 seconds but less than 5 seconds; the device reverts back to the same
operating mode as before activation.
2. Remote activation of the manual program: to activate this program it is necessary to close the
input and keep it closed (terminals
and restores the device to its previous state.
(only on battery-powered model)
) must be closed for at least 2 seconds, but not more than 5 seconds.
); reopening the input deactivates the manual program
Compiling the timed manual program
remotely
If you have chosen to connect a suitable
telephone interface A (
nals
up the screen in figure B.
A
Use the
temperature for the two types of remote
activation.
Note. A reference temperature must be
set for Heating mode
mode
B
two types of activation are
) to the termi-
, press the button to bring
arrows to set the reference
and Cooling
.