Miele HS18 Gebrauchsanweisung Seite 49

 Insert the supplied power supply plug
into the socket at the back of the
base station. You can wind excess
cable around the cable rewind. Guide
the cable through one of the two
cable runs (Fig. 06).
 Insert the country-specific power ad-
apter into the power supply until it
audibly engages and then plug it into
the selected power socket (Fig. 07).
Charging the battery (Fig. 08)
The rechargeable battery is supplied
not fully charged. Before using for the
first time, it must be fully charged while
the robot vacuum cleaner is switched
on (switch I/0 to I).
The battery can also be charged when
the robot vacuum cleaner is switched
off (switch I/0 to 0). In this case, the
vacuum cleaner indicators will not re-
act.
 Connect the robot vacuum cleaner
correctly to the charging contacts on
the connected base station.
As the rechargeable battery charges,
the status indicator flashes in the con-
trol field.
The charging process takes up to
180 minutes.
You can then vacuum for up to 2 hours.
Rechargeable battery status indic-
ator in the control field
Red Charged capacity approx.
0 % – 20 %
Or- Charged capacity approx.
ange
20 % – 50 %
Green Charged capacity approx.
50 % – 100 %
Setting the time of day (Fig. 09)
You can choose between a 24-hour
clock and a 12-hour a.m./p.m. clock.
Use the remote control to set the time
of day.
 Briefly press the Clock button.
24h will appear in the display.
 Press the OK button if you want a 24-
hour clock.
 Press the + button if you want a 12-
hour a.m./p.m. clock and confirm 12h
with OK.
The hour display flashes in the display.
 Press the + or - direction button to
set the current hour.
 Press the OK button to confirm your
selection.
The minute display flashes in the dis-
play.
 Press the + or - direction button to
set the current minutes.
 Press the OK button to confirm your
selection.
If you want to alter the time of day, pro-
ceed as described above, but press the
Clock button for 3 seconds.
en
49