Safety precautions
Safety precautions
WARNING
Ensure that the installation location is strong enough to support long-term use.
• If its strength becomes insufficient over the course of long-term use, the display may drop, possibly causing injury.
Fitting work and connection equipment expansion should never be done by any other than a qualified
installation specialist.
• Incorrect fitting may cause equipment to fall, resulting in injury.
Include a safety factor when considering the strength of the proposed fitting location.
• If strength is not sufficient the equipment may fall, resulting in injury.
Do not fit at a location that cannot bear the load.
• If the fitting location lacks sufficient strength the equipment may fall.
Do not disassemble or modify the installation mount.
• Otherwise the unit may be dropped and become damaged, and personal injury may result.
When there are people in the nearby area, do not move the display back and forth.
• Their fingers or hands may be caught between the display and the wall or the bracket resulting in injuries.
CAUTION
Do not use any television and displays other than those given in the catalogue.
• Otherwise the unit may be dropped and become damaged, and personal injury may result.
Do not fit at any locations subject to humidity, dust, smoke, steam or heat.
• This may have an adverse effect on the display and cause fire or electric shock.
The work of fitting or removing the display must be performed by at least 2 persons.
• The display may fall and cause injury.
Do not install facing upwards, downwards, sideways or upside-down.
• This may cause heat to build up inside the display unit, resulting in a fire.
Do not block the ventilation holes. When using the installation mount, do not block the space between
the rear surface of the display and the mount surface.
• Otherwise heat may build up inside and cause a fire.
Provide space of at least 10 cm (3.9 inches) above, below and to the sides of the main unit's outermost
surfaces, and at the rear provide space between the mounting surface and the bracket mount surface.
• Failing to do so may result in a fire.
Install the display by taking only the steps which are specified in these instructions: Do not install it in
any other way.
• Otherwise the unit may be dropped and become damaged, and personal injury may result.
Install the mounting screws and power cable in such a way that they will not make contact with the inside
parts of the wall.
• Electric shocks may result from contact with any metal objects inside the wall.
For installation, use the special-purpose constituent parts.
• Otherwise, the display may fall off the wall, possibly causing injury.
Be careful not to have your fingers pinched during installation work.
• It can cause injuries.
Dispose of the product when it is no longer going to be used.
• Otherwise the unit may fall over and become damaged, and personal injury may result.
Requests regarding handling
1) Exercise care when selecting the location for the display because it may discolor or deform due to light or
heat if it is placed where it is exposed to direct sunlight, or near a heater.
2) Clean the installation mount by wiping it with a soft, dry cloth (such as cotton or flannel). If the bracket is
very dirty, remove the dirt using a neutral detergent diluted in water, and then wipe it clean with a dry cloth.
Do not use benzene, thinner, or furniture wax as this may cause the coating to peel.
(For information on cleaning the display unit, see the display unit's instruction manual. If using a chemically-
treated cloth, follow the instructions supplied with the cloth.)
3) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the installation mount.
Do not allow long-term contact with rubber, vinyl products or the like. (Doing so will cause deterioration.)
4) Take care during installation as shocks can cause 'panel cracks' to the display unit.
Caution:
This bracket is intended for only Panasonic display models.
Use with other apparatus is capable of resulting in instability causing possible injury.
PROFESSIONAL INSTALLATION IS REQUIRED.
PANASONIC DISCLAIMS ANY PROPERTY DAMAGE AND/OR SERIOUS INJURY, INCLUDING DEATH
RESULTING FROM IMPROPER INSTALLATION OR INCORRECT HANDLING.
25