Zanussi ZQF11430DA Benutzerinformation Seite 22

Problem
There is too much frost and
ice.
The compressor does not start
immediately after pressing the
"FastFreeze", or after changing
the temperature.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
Door does not open easily.
22
Possible cause
The door is not closed correct-
ly or the gasket is deformed/
dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
This is normal, no error has oc-
curred.
The "FastFreeze function" is
switched on.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
The FastFreeze function is
switched on.
There is no cold air circulation
in the appliance.
Door was not closed com-
pletely.
Stored food was not wrapped.
You attempted to re-open the
door immediately after closing.
Solution
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
Switch off "FastFreeze func-
tion" manually, or wait until the
function resets automatically to
set the temperature. Refer to
"FastFreeze function".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "FastFreeze function".
Make sure that there is cold air
circulation in the appliance.
Make sure the door is closed
completely.
Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Wait a few seconds between
closing and re-opening of the
door.