Checking The Chain Brake; Checking The Chain Lubrication; Fitting The Saw Chain - FLORABEST FKS 2200 D2 Originalbetriebsanleitung

GB
7. The power saw switches off when
you release the On/Off switch
(10) again. Switching for continu-
ous running is not possible.

Checking the chain brake

The motor cannot be turned on if
the chain brake has engaged. Do
not employ the chain brake in order
to start the chainsaw or to switch it
off.
1. Place the electric chainsaw onto
E
a solid, flat surface. It must not
contact any objects.
2. Connect the device to the mains
voltage.
3. Release the chain brake by
shifting the brake arm (3) over
against the front grip (8).
4. Hold the electric chainsaw firmly
with both hands, with the right
hand on the rear handle
and the left hand on the front
handle (8). Thumb and finger
must close securely over the han-
dles.
5. Turn on the electric chainsaw.
6. Activate the chain braking lever
(3), with running motor, with
the left hand. To do so, push the
chain braking lever/front hand
protection (3) away from the front
handle (8). Chain should stop
abruptly.
7. Once the chain brake is work-
ing properly, release the on/off
switch (10) and the chain brake.
If the chain brake does not
function correctly, you must
not use the electric chainsaw.
A slack saw chain leads to
16
Checking the chain
lubrication
Check the oil level and the chain lubrica-
tion system before commencement of work.
• Switch on the chainsaw and hold it
above a bright background. The saw
must not touch the ground.
If an oil trace can be seen, the chainsaw is
working trouble-free.
J
4. Clean the oil passages of the
( 1)
A

Fitting the saw chain

1. Switch the saw off and unplug it
G
2. Spread the chain (5) out into a
3. Slide the saw chain (5) into the
danger of injury.
Return the electric chainsaw
to our Service-Center for re-
pair.
If no oil trace can be seen clean the
oil passages or turn the chainsaw
to our Service-Center for repair.
chain bar (27), in order to guar-
antee a trouble-free, automatic
oiling of the saw chain during
operation.
from the mains.
loop with the cutting edges run-
ning clockwise .
bar guide groove. To mount the
guide bar (4), raise it to an angle
of approx. 45 degrees. This will
make it easier to replace the saw
chain (5) onto the sprocket (25).
It is normal that the saw chain (5)
is slack. Sagging in the chain is
normal.