Dual Control Pixels - Chauvet Professional Maverick Storm 1 Wash Schnellanleitung

Operation

Dual Control Pixels

The Pixels protocol controls the individual output of the LEDs. Choose from DMX, Art-Net™, sACN, or
Kling-Net. In this mode, the three personalities available are: Basic (57 channels), Standard (76
channels), and Advanced (152 channels).
Dual Control Pixels Protocol
To select the Dual Control Pixels protocol, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Control Settings.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Dual Control.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select Pixels.
7. Press <ENTER>.
8. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from DMX, ArtNet, sACN, or KlingNet.
9. Press <ENTER>.
Dual Control Pixels Personality
To select the Dual Control Pixels personality, set the Protocol, then do the following:
1. Use <UP> or <DOWN> to select Personality.
2. Press <ENTER>.
3. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from Basic (57-channel), Standard (76-
channel), or Advanced (152-channel).
4. Press <ENTER>.
ArKaos Kling-Net can only be assigned the Basic and Standard Pixels personalities.
Dual Control Pixels Start Address
To set the starting address of the Dual Control Pixels mode, set the Protocol, then do the following:
1. Use <UP> or <DOWN> to select Start Address.
2. Press <ENTER>.
3. Enter the starting address (1–512) with one of the following methods:
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
4. Press <ENTER>.
Dual Control Pixels Universe
To set the Universe address of the Dual Control Pixels mode when using Art-Net™ or sACN, set the
Protocol to ArtNet or sACN, then do the following:
1. Use <UP> or <DOWN> to select Universe.
2. Press <ENTER>.
3. Enter the universe address (0–255 for Art-Net™, 0–255 for sACN,) with one of the following
methods:
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
4. Press <ENTER>.
Maverick Storm 1 Wash User Manual Rev. 2
Home Screen shows on the display. Press <ENTER>.
Page 16 of 306