Safety System; Start-Up; Switching On / Off / Selecting The Temperature - Silvercrest SSHK 100 C3 Bedienungsanleitung Und Sicherheitshinweise

pad was used improperly or will
no longer heat up, it must first be
inspected by the manufacturer
before being switched on again.
If the power cord of the heating
pad is damaged, it must be re-
placed by the manufacturer or
its service department, or a simi-
larly qualified person, to avoid
hazards.
With the heating pad switched
on, never
– place objects on it (e.g. suitcases
or clothes baskets),
– place a heating source such
as a hot-water bottle, heating
pad or similar items on it. The
heating pad may otherwise be
damaged.
The electronic components inside
the control unit will heat up whilst
operating the heating pad. For
this reason, the control unit must
not be covered or be lying on the
heating pad during operation.
This poses a risk of injuries and /
or damage to the heating pad.
Always observe the information
on start-up, cleaning and care,
and storage.
If you have additional questions
on using our products, please
contact our Customer Service
Department.
Important safety instructions / Safety system / Start-up

Safety system

Note: The heating pad is equipped with a safety
system. The electronic sensor technology prevents the
entire surface of the heating pad from overheating
by automatically switching off in the event of a fault.
If the safety system switches the heating pad off au-
tomatically due to a fault, then the function display
on the control unit
if the heating pad is switched on.
Please note that, for safety reasons, the heating
pad must not be used after a fault and must be
returned to the service address indicated.

Start-up

Note: The heating pad may smell of plastic the first
time you use it, but this will disappear after a short
period of time.
To begin, first connect the control
ating pad with the plug-in connector
fig. B).
Place the heating pad in position as shown in
Fig. C.
Push the two ends of the heating pad together
so the press stud
Or use the two press studs
of the heating pad.
To place the heating pad down, undo the press
stud
Switching on / off / Selecting
the temperature
Switching on:
Set the control unit
switch on the heating pad.
Note: The function display
the heating pad is switched on.
Note: This heating pad features rapid heating,
which allows it to heat up within the first 10 mi-
nutes of operation.
is no longer illuminated, even
1
snaps into place.
4
5
or the press studs
4 5
to 1, 2, 3, 4, 5 or 6, to
1
2
to the he-
1
(see
3
for a tighter fit
.
illuminates after
2
GB 9