Secondary Output Connections For Mechanized Cutting; Pt-37 Torch Installation - ESAB Powercut-1300 Bedienungsanleitung

SECTION 3
3.8 Secondary Output Connections Mechanized Cutting
Torch Cable
Clamp the work cable to
the workpiece.
WArNINg
3.9

PT-37 Torch Installation

1. Open torch lead access door on the front panel of the Powercut-1300/1600.
PT-37 Torch
Be sure the workpiece is connected to an approved
earth ground with a properly sized ground cable.
figure 3-4. Powercut Interconnection Diagram
MAKE SUrE POWEr SWITCH ON CONSOLE IS IN Off POSITION AND PrIMA-
rY INPUT POWEr IS DE-ENErgIZED.
Torch Lead
Access
Door
137
INSTALLATION
SAFETY GROUND