Operating Elements And Connections; Front Side; Rear Side - Monacor DSM-26LAN Bedienungsanleitung

All operating elements and connections described can be found on page 2.

1 Operating Elements and Connections

1.1 Front side (fig . 1)
1 USB jack, type B, to connect a computer for remote control of
DSM-...
2 LED chains to indicate the input signal levels for the analog inputs
When an input is overloaded, the corresponding LED indicator
CLIP will light up; in this case, reduce the output level of the
signal source accordingly .
When the limiter or compressor is active, the corresponding LED
indicator LIMIT will light up .
3 LED chains to indicate the input signal levels for the digital inputs
(AES/EBU and Dante)
When an input is overloaded, the corresponding LED indicator
CLIP will light up; in this case, reduce the output level of the signal
source accordingly .
When the limiter or compressor is active, the corresponding LED
indicator LIMIT will light up .
4 Buttons to operate the setting menu
CH/: to select an input channel or output channel
ITEM /: to select a signal processing function
MENU: to select the system menu and to select a menu item
EXIT: to exit the system menu
5 LC display
6 Button COPY to copy settings between channels
7 Rotary knob SELECT/ENTER to select or change a setting
For some settings, press the knob to confirm the value set and to
go to the next parameter .
8 Button PASTE to assign the setting copied by means of the button
COPY to the channel currently selected . Press the rotary knob (7)
to confirm .
9 Buttons MUTE to mute an output
When an output is muted, the LED indicator next to the corre-
sponding button will light up .
10 LED chains to indicate the output signal level
When an output is overloaded, the corresponding LED indicator
CLIP will light up; in this case, use the setting "Gain" to reduce
the output level accordingly .
When the limiter or compressor is active, the corresponding LED
indicator LIMIT will light up .
1.2 Rear side (fig . 2)
11 POWER switch
12 Support for the mains fuse
Always replace a blown fuse by one of the same type .
13 Mains jack for connection to a mains socket (230 V/ 50 Hz) by
means of the mains cable supplied
14 Balanced audio signal outputs OUT 1 – 8 (DSM-26LAN: OUT 1 – 6)
as XLR connectors
15 LAN connection RJ45 to connect a computer for remote control of
the DSM-...; for the DSM-48DT, also to insert digital audio signals
from a Dante network
16 XLR jack AES / EBU to connect a digital audio signal source
17 Balanced audio signal inputs IN A – D (DSM-26LAN: IN A – B) as XLR
jacks to connect analog signal sources
23