Invacare FUTURA Bedienungsanleitung Seite 15

- Make sure they are level (see figure 7).
Cover the seat which you have already installed to protect it
against drilling dust.
- Drill the holes in the wall (drilling diameter = 10 mm) and
fit the plate preferably using the screws included in the stan-
dard tool set (except for R6600 model)
Use the steel sections included in the tool set to hide the
fixing screws (see figure 8)
Adjust to the right leg height by unscrewing the adjustable
foot supports (if ordered) (see figure 9)
Figure 8
Figure 7
Fitting the support legs after assembly.
l
- You have to order the adjustable support legs
corresponding to the chosen height (R855, R860, R865)
- Drill in the mark located on the right side of the seat to
insert the support rod (see figure 10).
- Take the plastic caps off the seat underside to fit the sup-
port legs tubes. (see figure 11)
- Screw the tubes and adjust to the right leg height by
screwing / unscrewing.
Folding the seat
l
The seat can easily be lowered and raised.When in raised po-
sition, the seat should remain firmly in position. If not, please
consult your dealer.
Figure 9
Figure 10
13
Figure 11