Yamaha YDRE Serie Benutzer-/Betriebsanleitung Seite 41

MAINTENANCE
1
Visually and manually inspect to
verify that the DC output cord,
plug and battery charging
2
receptacle are in good working
condition before each and every
use. Do not use the charger under
3 any of the following conditions:
The DC charging receptacle does
G
not grip the DC cord set plug
tightly, is loose or does not make
4
a good electrical connection.
The DC cord set plug or
G
charging receptacle feels hotter
5
than normal.
The DC cord set plug or
G
charging receptacle contacts are
bent, corroded, or are dark or
6
bluish in appearance.
The DC cord set plug, cords,
G
receptacle or equipment-
7
charging wiring are cut, worn,
broken or have any exposed
conductors.
The DC cord plug, cords, charger
G
8
or receptacles are damaged or
distressed in any way.
Using the charger with any of the
9
above symptoms could result in a
fire, property damage or personal
injury.
10
Do not disconnect the DC cord set
plug from the DC charger
11
receptacle when the charger is on.
If the charger must be stopped,
first disconnect the AC power
supply cord from its AC outlet, and
then disconnect the charger DC
cord set plug from the DC charger
receptacle.
7-13
Whenever removing AC or DC cord
set plugs from receptacles, pull
from the plug body and not from
their respective cords.
The instructions printed on the
charger (shown below) are for daily
reference. The charger is factory
preset for use with Trojan 48-volt PTV
batteries.
OPERATING INSTRUCTIONS
1. PLUG AC CORD INTO A
GROUNDED RECEPTACLE
2. PLUG DC CORD INTO DC
CHARGER RECEPTACLE
3. CHARGE CYCLE WILL BEGIN
AFTER A FEW SECONDS AND
AMMETER WILL TURN ON
4. CHARGER SHUTS OFF
AUTOMATICALLY WHEN
BATTERIES ARE CHARGED
Connect charger's AC cord set to AC
power. Then, connect the DC cord
set plug to the vehicle charging
receptacle by grasping the plug
handle and pushing the plug straight
into the DC charger receptacle. The
charger will start automatically.
Upon connection to AC power
source, the lower four LEDs come
on as a Power-On Self-Test, then the
AC power LED turns on. Upon
connection to battery pack, output
indicators turn on to indicate charging
is active.
Y-669c
JC1