Lens Wiring - Bosch UHI Serie Benutzerhandbuch

UHI/UHO Series
4.
5.9

Lens wiring

1.
CAUTION!
Use only cables meeting specifications in Section 5.3 Cable
requirements, for wiring cameras and lenses.
2.
CAUTION!
Always securely tighten all fittings to ensure a liquid-tight seal.
Failure to do so could allow water to enter the housing and
damage the camera and lens. If a sealant is used, be sure it is a
neutral cure type. Sealants that release acetic acid may harm
camera electronics. Use of drip loops is recommended on the
wiring outside of the rear end cap.
3.
4.
For correct plug connection, see specification on lens cord.
Bosch Security Systems, Inc.
Pull any excess wire out of the housing and tighten the
fitting to 8.5 Nm to 9.0 Nm (75 inch-lb to 80 inch-lb). This
torque rating is approximately one to one and a half turns
past the point where the fitting starts to grip the wire.
Install the 3/8-inch NPT fitting into the middle hole in the
rear cap.
If installing a zoom lens, insert the lens control cable
through the last fitting at the rear of the housing. Attach
the lens wiring to the lens mating connector and connect it
to the lens. If a mating connector is not available, connect
directly to the lens cable.
Pull any excess wire out of the housing and tighten the
fitting to 8.5 N m to 9.0 N m (75 in-lb to 80 in-lb). This
torque rating is approximately 1 to 1-1/2 turns past the
point where the fitting starts to grip the wire.
If using a pan/tilt with a feed-through cable, insert the
camera/lens function cable through the left fitting at the
rear of the housing. Wire the required functions.
Installation Manual
Installation | en
F.01U.167.418 | 3.0 | 2010.04
69