EUROM 24.709.1 Bedienungsanleitung Seite 33

Option 1: Weed remover
Securing extension rod (with handle)
The extension rod (with handle) can only be attached to the weed burner in one way.

Position the arrow marks on the extension rod/handle directly opposite the open padlock
marks on the weed burner.

Press the extension rod firmly into the weed burner and turn the extension rod/handle to the
right until the arrow marks are directly opposite the closed padlock marks on the weed
burner.

Make sure that the extension rod clicks into the device properly. The device may only be
used as a weed burner with the extension rod. Hold the weed burner by the handle.
Initial use

Make sure that the extension rod/handle is secured properly and that the machine is
switched off.

Check to ensure that all of the relevant safety measures have been applied.

Secure the mouthpiece to treat the weeds.

Insert the plug into the socket.

Guide the electrical cable through the cable clamp (and the extension cable, if used) and
away to the back.

Check to ensure there is nothing in front of the mouthpiece before you switch the device on.

Set the temperature to setting II.

Let the device warm up for around 45 seconds.

To remove the weed, place the mouthpiece over the plant for around 5 seconds.

During this time, the cell structure of the weed will be destroyed. The weed will then die
within a few days.

It is not necessary to burn the weed, 5 seconds is all it takes to kill it.

For effective treatment, the mouthpiece must be placed 0-5 cm from the weed.

The effects are not immediately visible; it may take a few days before you can see the
difference. You are making a long-term difference.

If you are treating plants with hard leaves, you may have to repeat the process at intervals of
1 to 2 weeks.
33