Assembling The Sparkling Beverage Maker; Installing The Sodastream Co; Before First Use - KitchenAid 5KSS1121 Handbuch

ASSEMBLING THE SPARKLING BEVERAGE MAKER

Installing the SodaStream CO

Before First Use

Place the Sparkling Beverage Maker on a
flat, sturdy surface, in an upright position.
Remove packaging materials.
The Sparkling Beverage Maker uses
3 AAA batteries. To replace batteries,
see the "Care and Cleaning" section.
Remove seal and cap from SodaStream
2
CO Cylinder. Insert 60 L* SodaStream
2
CO Cylinder into the Sparkling
2
Beverage Maker. First tip downward
into the base and then push upward
into the valve fitting.
To reinstall back cover: tilt back cover
4
toward you; insert bottom tab into slot
and push cover into place.
* The 60 L SodaStream Cylinder produces up to 60 litres of sparkling water, depending
on the level of carbonation.
10
Cylinder
2
To remove back cover: Grasp back
1
cover and pull away from unit. Set
cover aside.
Turn the SodaStream CO
3
counterclockwise until it stops.
Hand-tighten only.
Cylinder
2