Quick-Start Function "Boiling; Switching Off The Appliance - Rommelsbacher TA 2000 Bedienungsanleitung

Quick-start function „Boiling"
NOTE: If the glass jug is lifted during the quick-start function, the appliance stops the preparation and
returns to selection mode.
• The display of the set temperature is flashing for a short time. Then the current temperature inside the
jug is displayed. Display "1" is flashing, the button "Boiling" is lit.
• The water is heated up to the set temperature. In the display, the temperature is changing in 1-°C steps.
• As soon as the boiling process is finished, there is a double signal tone. The appliance returns to selection mode.

Switching off the appliance

• The programme sequence respectively the function of the appliance can be interrupted at any time and
the appliance can be switched to selection mode.
• To do so, press the button "Start/Stop" for 2 seconds.
Pressing the button is confirmed with a signal tone.
• For a safe and permanent switch-off of the appliance, disconnect the mains plug
from the socket after every use.
32
• For selecting the quick-start function for boiling water, press the button
"Boiling". Pressing the button "Boiling" is confirmed with a signal tone and
the button is lit permanently.
NOTE: If within 1 minute no further button is pressed, the appliance changes to
standby mode and the display is off.
• For starting the quick-start function, press the button "Start/Stop".
Pressing the button "Start/Stop" is confirmed by a signal tone and the button
is lit permanently.