Starting The Programme And Preparation; A) Programme Phase "1" - Heating-Up Water; B) Programme Phase "2" - Inserting The Tea Infuser - Rommelsbacher TA 2000 Bedienungsanleitung

Starting the programme and preparation (example "Herbal")
NOTE: The process of making tea consists of 4 phases in all ("Heat-up" only of phase 1).
a) Programme phase "1" – Heating-up water
NOTE: If the glass jug is lifted during programme phase "1", the appliance stops the preparation and
returns to selection mode.
• The set temperature (here 100 °C) is flashing in the display for a short time. Then the current
temperature (here 23 °C) is displayed inside the jug. On the display "1"is flashing.
• The water is heated up to the set temperature. In the display the temperature is changing in 1-°C steps.
• As soon as the set temperature (here 100 °C) is reached, there is a double signal tone.
• The appliance automatically switches into programme phase "2".
b) Programme-phase "2" – Inserting the tea infuser
NOTE: If the glass jug is lifted during programme phase "2", the appliance stops the preparation and
returns to selection mode.
• The display shows "10:00" and display "2" as well as the button "Start/Stop" are flashing.
There are 10 minutes left to insert the tea infuser and to activate the steeping time.
• If this does not happen, the programme is quit and the appliance switches to selection mode.
• The time counts downwards in 1-sec. steps.
NOTE: As a reminder that the appliance is waiting for a further operation, there is a multiple signal tone
after 2 minutes.
• When the desired settings are done, press the button "Start/Stop" for starting
the appliance.
Pressing the button "Start/Stop" is confirmed by a longer signal tone and the
button is lit permanently.
29