Technical Specifications - Okay GS 8014 LI Gebrauchsanweisung

Accu Grass shear GS 8014 LI

Technical Specifications

Battery voltage/operation voltage
Battery type
Operating time
Idle speed n
0
Cutting width
Guaranted acoustic capacity level
Noise pressure level as per (DIN EN 60745-2-15)
Vibrations (DIN EN 60745-2-15)
Mains battery charger
Mains voltage
Charging voltage
Charging current
Charging time
Technical changes are reserved.
- The specified vibration emission value was measured by a standardized test methods and can compare with other
power tools are used.
- The specified vibration emission value can also be necessary for the assessment of work breaks are used.
- The specified vibration emission value can vary during the actual use of the electric tool by specifying the value,
depending on the way how to use the power tool.
- Note: You create the privilege against vascular pulsations of the hands in time breaks.
- Try to keep the stress due to vibration as low as possible. For example, measures to reduce vibration stress are
wearing gloves when using the tool and limiting the work time. All phase of the operating cycle must be considered
in this regard, (for example, times when the power tool is switched off, and times when the power tool is switched
on but is not running under load).
- Always keep hands and feet away from the cutting tools, particularly when switching on the motor!
GB | Operating Instruction
2
V/DC 7,2
Ah/Wh 2,0 / 14,4 / lithium-ion
min. approx. 160
-1
min 1000
mm 75
dB(A) 92
dB (A) 80
2
m/s 1,024
V~ / Hz 230 / 50
V DC 7,2
mA 550
approx. 3-5 hours
h
K=3,0 dB (A)
2
K=1,5 m/s