Adjusting The Torque; Initial Use; Changing Rotation; Correctly Holding The Equipment - Parkside PDSS 400 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Only use filtered, lubricated and regu-
„ „
lated compressed air.
z Adjusting the torque
Set the torque control
„ „
torque by pressing it toward the housing
and turning it until it locks at the desired
setting.
Be sure the operating pressure of the
„ „
compressor is between 5 and 6.3 bar.
Note: the ideal pressure is 6.3 bar. The
maximum torque cannot be reached at a
pressure of only 5 bar or with insufficient air
flow.
ATTENTION! Car/truck - do not tighten
wheels with the highest torque (F
- strong). If the torque is too high, it may
result in damages.
ATTENTION! The correct torque must
be examined using a torque wrench
once the pneumatic impact wrench has
been used.
Setting
R open
tighten
F
(low)
tighten
F
(normal)
tighten
F
(high)
1 to the correct
R F
Commissioning / After initial use
z Initial use
Activate the trigger
„ „
ment.
Release the trigger
„ „
equipment.
z Changing rotation
ATTENTION! The device must come to
a complete standstill before changing
the direction of rotation.
ATTENTION! A machine rotating in an
unexpected direction can be dangerous.
Always pay attention and use care.
Note: The impact driver clockwise /
counter- clockwise rotation. Use the
rotary switch
1
of the impact driver.
Turn the rotay switch
„ „
wards the "F" mark („Forward / Fasten")
for clockwise operation. You can choose
between three different torques (see
"Set torque") You can now e.g. tighten
screws.
Turn the switch to the left towards the "R"
„ „
mark ("Reverse/Release"). This setting
changed the direction of rotation. You
can now e.g. loosen screws.
z Correctly holding the
equipment
This equipment weighs 2.1 kg.
Hold the equipment with both hands to
„ „
ensure safe operation (see Fig. D).
z After initial use
Once the task has been finished the device
to start the equip-
3
to deactivate the
3
to change the direction
1 to the right to-
GB/MT 59