Operation And Maintenance - GRAPHITE 59G872 Betriebsanleitung

CUTTING
The return spring of the saw arm automatically moves the head to upper position. Therefore, do not
release pressure on the handle after cutting, instead hold it slightly and allow the head to return to
the topmost position.
● Fix the material tightly in the vice (5).
●
Switch on the portable cut off saw and wait until motor reaches its full rotational speed.
●
Use the handle ( 11) to press the head (19) downwards until the cutting disc (3) slightly contacts the
material to cut.
●
Apply steady pressure on the head and make a cut (
Do not reduce pressure at the end of a cut, otherwise the cut material may get overheated and there may
be uneven edges.
Do not allow vibrations or cutting disc bouncing on material, it would adversely affect cut quality
and may cause crack in the cutting disc.
CUTTING LARGE PIECES
When fixing a wide piece of material, you can move the fixed jaw away to increase distance between vice
jaws.
● Set the head (19) in upper position.
●
Unscrew the fixing screws for fixed jaw (
●
Reinstall the fixed jaw (
screws for fixed jaw (17).
Number of cuts possible to do with cutting disc and quality may vary, depending on the cutting speed. Fast
cutting may cause early wear of cutting disc, but protects the material against overheating and ensures
smooth cut surface.
SETTING THE VICE FOR MITRE CUTTING
The fixed jaw (16) also has a function of mitre gauge and allows to cut material at any angle after adjustment
within range from right angle position to 45
● Set the head (19) in upper position.
●
Loosen the fixing screws for fixed jaw (
●
Turn the fixed jaw ( 16) to required cutting angle accordingly to the angle scale and secure position by
tightening the fixing screws for fixed jaw (17) loosened earlier (fig. G).
●
Fix material in the vice and make a cut.
Even though the angle scale in fixed jaw is accurate enough for most of performed tasks, it is recommended
to double-check the cutting angle with protractor or other device for angle measurements.
When fixing material in the vice, the sliding jaw (15) aligns itself in parallel to fixed material, ensuring it is
well secured.
Unplug the power cord from mains socket before commencing any activities related to installation,
adjustment, repair or maintenance.
● When the work is finished, remove thoroughly all pieces of material and dust from the base and area
around cutting disc and its shield.
●
Clean the portable cut off saw with brush or stream of compressed air.
●
Never use water or other chemical liquids for cleaning the portable cut off saw.
●
Clean ventilation holes regularly to prevent motor overheating.
●
Store the portable cut off saw in a dry place, beyond reach of children.
●
Entrust replacement of power cord and other repairs only to authorized service workshop.
17).
16) to holes located closer to the head arm and attach by tightening the fixing
0
left or right.
17).

OPERATION AND MAINTENANCE

fig. F).
16