Safety Instructions; Danger Of Tripping - Bosch TTM 2104 Originalbetriebsanleitung

Tests (taking Germany as an example):
R
The workshop operator must ensure that all
electrical systems and equipment are tested by
a qualified electrician or under the guidance of a
qualified electrician to ensure they are in proper
working order:
$
Before starting for the first time.
$
After modification or repair before starting for
the first time.
$
At given intervals. Set intervals such as to ensure
that faults that can be expected to occur are
determined in good time.
R
The test is to take the electrical engineering
principles relating hereto into account.
R
Upon request of the trade association, a test manual
is to be maintained into which specific entries are
made.
Robert Bosch GmbH
Safety instructions | TTM 2104 | 33 | en
3.

Safety instructions

3.1 Mains voltages
Hazardous voltages are present both on the
lighting mains and electrical systems of a
motor vehicle.
Safety measures:
¶
Never touch live parts or components with damaged
insulation.
¶
Only connect TTM 2104 to a properly grounded
connection.
¶
Electrical connection only to be performed by a
qualified electrician.
¶
Replace cables with damaged insulation.
¶
Inspect/check the electrical equipment every 2 years
in conjunction with the test service and rectify any
defects immediately.
¶
Prior to maintenance and repair work, unplug the
mains connector or switch off the main switch
for the power supply in the case of a permanently
connected power cord.
3.2

Danger of tripping

Sensor and connecting cables cause heightened
danger of tripping during test and installation
work.
Safety measures:
¶
Route the connecting cables such that there is no
risk of tripping.
3.3 Eye safety
No requirements and no measures
are required.
Recommendation: Whenever possible do not look into
the source of the beam.
Use optional tinted glasses (OD1, optical density).
|
1 691 206 005 2017-10-25