Troubleshooting - SOLAC TE7803 Gebrauchsanleitung

TROUBLESHOOTING:

The following messages can appear on the screen:
Message Cause
E1 The cuff is too loose.
E3 The maximum pressure
of the cuff has been
exceeded
E10 / E11 Moving or talking during
the measurement.
E20 The measurement pro-
cess does not detect the
pulse signal.
E21 Measurement failure.
EExx A calibration er-
ror occurred
(EE1,EE2,EEa,...).
Out Out of measurement
range.
Low battery power.
+
In the event that it does not switch on after pressing the Start/Stop
button or having changed the batteries, take the appliance to your
Authorised Technical Support Centre.
How to correct
Confirm the cuff is wrapped
up correctly, retake the meas-
urement.
Relax for a moment. Confirm
the cuff is wrapped up cor-
rectly and retake the meas-
urement.
Remain still, confirm the cuff
is wrapped up correctly and
retake the measurement
Confirm the cuff is wrapped
up correctly and retake the
measurement.
Relax for a moment. Confirm
the cuff is wrapped up cor-
rectly and retake the meas-
urement
Retake the measurement. If
the problem persists, contact
the retailer or our customer
service department for further
assistance.
Relax for a moment. Refasten
the cuff and then measure
again. If the problem persists,
contact your doctor.
Change the batteries.
EN