Optional Accessories; General; Scope - ESAB Powercut 650 Bedienungsanleitung

SECtIoN 2

Optional Accessories

torch guide Kits
The Deluxe kit, in a rugged plastic carrying case, includes
attachments for circle and straight line cutting on ferrous and
non-ferrous metals
Deluxe: 44.5mm - 1,066.8mm (1 3/4" - 42") Radius .......... 0558003258
Basic: 44.5mm - 711.2mm (1 3/4" - 28") Radius .................. 0558002675
Plasma flow Measuring Kit
This valuable troubleshooting tool allows measurement of
the actual plasma gas flow through the torch ....0558000739 (19765)
Input receptacle
230vac/50Amp, 3 Prong ........................................................................674540
torch Wrap and Spare Parts Kit Holder
This enables operator to store S/P Kit, wrap torch and
work cable for easy transport and storage ........................... 0558003398
Wheel Kit
For easy transport of system ...................................................... 0558003399
PoWErCut shown with optional torch Wrap
and Spare Parts Kit Holder installed.
PT-31XLPC Replacement Torch
Torch comes assembled with Long "CE" Heat Shield, Nozzle, Electrode,
and Swirl Baffle.
PT-31XLPC Spare Parts Kit (P/N 0558005392) includes:
Heat Shield, Long (1) ..........................................................0558000509 (36284)
Nozzles, High Performance (3) .......................................0558000512 (20860)
Swirl Baffle (1) .......................................................................0558000506 (20463)
Electrodes (2) ........................................................................0558000507 (20862)
Plunger
Electrode
0558000511
0558000507
(20324)
(20862)
Nozzle
0558000512
(20860)
Swirl Baffle
0558000506
(20463)
Heat Shield
0558000509
*
Includes the following items:
(36284)
O-ring - 0558000514 (950790)
WArNINg
Do not use any torch with this power source
other than the ESAB brand Pt-31xlPC
torch. Serious injury may occur if used with
any other torch.

2.0 gENErAl

The POWERCUT 650 is a compact, completely self-contained
plasma cutting system. As shipped, the system is fully as-
sembled and ready to cut after being connected to input
power and a source of prefiltered compressed air (6.2-10.3
bar / 90-150 psig). The POWERCUT 650 package uses the
PT-31XLPC torch to deliver cutting power for materials up
to 15.9mm (5/8-in.) thick or for severing up to 19.1mm
(3/4-in.) thick.

2.1 SCoPE

The purpose of this manual is to provide the operator
with all the information required to install and operate the
POWERCUT 650 plasma arc cutting package. Technical refer-
ence material is also provided to assist in troubleshooting
the cutting package.
102
INtroDuCtIoN
......................................... 0558005393
Torch Body
*
0558000790
(20072)
Seat
0558000510
(19679)
Seat - 0558000510 (19679)