Switching On And Off; Checking The Battery Charge Level; Working With The Hedge Trimmer; Cutting Techniques - FLORABEST FHSA 20 B1 Originalbetriebsanleitung

GB IE NI
Reduce the risk of injuries and
accidents by wearing person-
al protection equipment and
ensuring that the unit is fully
functional.
Note noise protection and local
specifications.

Switching On and Off

Ensure that you are standing in a
firm position with both hands grip-
ping the hedge trimmer away from
the body. Ensure that the trimmer
is in contact with no other objects
before switching on.
Removing the blade guard:
1. Press the blade guard (
the points marked
and remove it.
Turning on:
2. Check that the battery (9) is in
(see "Removing/inserting the
battery").
3. Press the safety switch (4) at the
front handle (5).
4. Press the On/Off switch (7). The
hedge trimmer will run at top
speed.
Turning off:
5. Release the safety switch (4) or
the On/Off switch s (7).
Checking the battery charge
level
The battery's ( 9) charge level is indicat-
ed by the charge state indicator (
14
Press the button for state of charge display
(
the battery's charge level.
3 LEDs are on: Battery charged
2 LEDs are on: Battery partially charged
1 LED is on: Battery needs to be charged
Working with the Hedge
Trimmer
14) at
press
• If the blades become jammed with
solid objects, turn the device off imme-
diately and remove the rechargeable
battery. Only then should you remove
the object.
• Avoid overstraining the equipment dur-
ing work.

Cutting Techniques

• Cut thick branches beforehand using a
branch clippers.
• The double-sided cutter bar enables
cutting in both directions or, with a
swinging action, from one side to the
other.
• In case of vertical cutting, move the
hedge trimmer uniformly forward or up
and down in an arc movement.
• In case of horizontal cutting, move
10a). the hedge trimmer in a sickle-shaped
movement to the edge of the hedge, so
10) on the battery. The LEDs indicate
Only charge the battery (
when the red LED on the charge
level indicator is on.
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage to
the cutter bar.
9)