FALMEC Quantum Gebrauchsanweisung Seite 19

Control description
Cooker top ON/OFF. In case no other control is
enabled, the cooker switches off automatically after
a few seconds
Selection of the front cooking area. If pressed
together with
Selection of the back cooking area. If pressed
together with
Control block: pressed for more than 2 seconds it
inhibits all controls. To release controls, repeat the
operation.
Increase of the power level for cooking and booster
selection, or increase of cooking time of the TIMER
function.
Decrease of the power level for cooking and booster
selection, or decrease of cooking time of the TIMER
function.
Display description
display
Cooking area in stand-by
Levels of power from the lowest to the highest one,
which can be selected pressing the keys + and -.
Power boost : maximum cooking power.
Indication of the residual heat
level of power between 0 and 1, suitable to keep dish-
es warm
bridge function enabled.
(minimum saucepan diameter: Ø230 mm)
Saucepan not on the cooker or not suitable for ma-
terial and size.
(minimum saucepan diameter: Ø 120 mm)
Control block function enabled.
(su
+
display
centrale)
OPERATION AND
USE OF THE COOKTOP
ONLY USE COOKWARE SUITABLE FOR INDUCTION HOBS.
When a cooking are is turned on, the bottom of the saucepan heats.
The cooking area only heats thanks to the heat given by the saucepan.
The cooktop automatically detects the size of the saucepan.
The heating power is to be chosen based on what shall be cooked.
Please find below a short table:
it enables the BRIDGE function.
it enables the BRIDGE function.
SETTING AREAS
1 - 2
Melt
Heat
2 - 3
Whisk
Defrost
3 - 4 Steam
4 - 5
Boil
6 - 7 Cook over a low heat
7 - 8 Cook
Fry
9
Fry, bring to the boil
P
Fry, bring to the boil
Remark: heating time of cooktops is shorter than the gas cookers.
BASIC FUNCTIONS
See table of the corresponding model in the previous page.
BRIDGE FUNCTION
This function allows having cooking areas 1-2 and/or 3-4 working at the same
time.
To enable:
- Enable the cooktop;
press simultaneously the symbols
- the symbol will be displayed on the screen of the front cooking area;
- Push the keys + and – to set power.
Note: this function can only be activated between the 2 right or the 2 left
plates (not the two centre plates).
DEACTIVATION of the BRIDGE function:
press simultaneously the symbols
BOOSTER FUNCTION
The Booster strengthens power, so that big quantities can be heated (e.g.
water to cook pasta).
This power increase is enabled for max. 10 minutes.
- Turn on the cooker;
- select the cooking area;
- touch (+) until on the screen
Note: it is not possible to only set to
time (and no more than 2 in total).
If the 1 (4) is set to , the one near 2(3) cannot be set to exceed the
level.
If the 2(3) plate is set to , the 1(4) one switches off.
KEEP WARM FUNCTION
42°C - Keeping temperature of cooked dishes:
Turn on the cooker;
Select the cooking area;
Touch (+) and then (-): the symbol will appear.
Shutdown of the cooker
To shutdown the cooking area:
Touch the key ( - ) until 0 is displayed on the screen of the cooking area.
If the cooking area is still too hot, the residual heat is specified
Turn off the cooker
Touch the key : all cooking areas are deactivated.
On the display of the cooking areas that are still too hot, the symbol is dis-
played .
Do not touch the cooking areas until the lamp
19
Sauces, butter, chocolate,
gelatine
Precooked dishes
Rice, pudding and cooked
dishes
Vegetables, fish, frozen food
Vegetables, fish, meat
Boiled potatoes, soups, pasta
Fresh vegetables
Meat, liver, eggs, sausages
Goulash, rolate, tripe
Potatoes, donuts, cakes
Steaks, omelettes
Boil
Bring to the boil big
quantities of water
+ ::
+ :.
is displayed on the back cooking area.
one right or one left plate at the
.
is on.