Installing And Adjusting The Shoulder Harness; Oil And Fuel Information - Ryobi RGBV3100 Benutzerhandbuch

INSTALLING AND ADJUSTING THE SHOULDER
HARNESS
NOTE: Have the shoulder harness on and adjusted, but
not clipped to the support fitting prior to starting
unit.
1. Push the strap through the center of the buckle.
2. Pull the strap over the cross bar and down through
the slot in the buckle (Fig. 6).
3. Fully extend the harness.
4. Attach the metal clip of the shoulder harness to the
support fitting on top of the handle (Fig. 7).
Clip
Old and/or improperly mixed fuel are usually the main
reasons for the unit not running properly. Be sure to use
fresh, clean fuel and follow the instructions carefully for
the proper fuel/oil mixture.
RECOMMENDED OIL TYPE
Use a high quality synthetic oil formulated for use in 2-
cycle,
air-cooled engines.
RECOMMENDED FUEL TYPE
Always use clean, fresh, unleaded petrol (gasoline) that
is less than 60 days old.
8
ASSEMBLY INSTRUCTIONS
Clip
Fig. 6
Support Fitting
Fig. 7

OIL AND FUEL INFORMATION

5. Place the harness over your head and onto your
shoulder (Fig. 8).
6. While standing in the operating position (Fig. 8)
adjust length to fit the operator's size.
• Lengthen the harness by pulling down on the strap
and lifting the buckle end up (Fig. 9).
• Shorten the harness by pulling the strap back
through the buckle while holding the buckle (Fig. 9).
WARNING: petrol (gasoline) is extremely
flammable and its vapors can explode if they
are ignited. Always stop the engine and allow
it to cool before filling the fuel tank. Do not
smoke while filling the tank. Keep sparks and
open flames away from the area.
OIL AND FUEL MIXING INSTRUCTIONS
Thoroughly mix 5 liters of unleaded petrol (gasoline) with
100 ml. of 2 cycle engine synthetic oil in a separate fuel
can, (50:1 = 2%). Do not mix them directly in the engine
fuel tank.
Fig. 8
Fig. 9