Operation - Silvercrest SDM 1500 C2 Bedienungsanleitung

Operation

CAUTION – PROPERTY DAMAGE!
► If you are not sure whether the floor is suitable for cleaning, please carry
out a tolerance test using a concealed part of the floor.
► Always comply with the cleaning instructions of the carpet manufacturer.
Before cleaning, check also whether the carpet is suitable for steam clean-
ing.
► Never use the appliance without a pad
Otherwise the floor could get scratched!
► Never operate the appliance without water in the water tank
The pump could overheat and be damaged!
NOTE
► Before you clean the floor with the steam mop, we recommend that you
vacuum the floor to remove any loose particles of dirt.
Once the appliance is assembled and filled with water:
1) Press and hold in the "Handle" release button
wards so that it clicks into place.
2) If not already done: Completely unwind the power cable from the cable
hooks
upper cable hook
3) Run the cable through the notch
cable does not hang down into the working area.
4) Insert the plug into the mains power socket.
5) Set the on/off switch
POWER control lamp
6) Use the MODE button
–
Press 1 x: low steam level, green control lamp
–
Press 2 x: high steam level, red control lamp
–
Press 3 x: no steam, standby, POWER control lamp
NOTE
► We recommend the high steam level especially for moisture- and heat-
resistant floor coverings, such as tiles.
► We recommend the low steam level especially for moisture- and heat-
sensitive floor coverings, such as parquet flooring.
7) Wait around 30 seconds while the appliance heats up.
8) Press the "Steam" button
after a short time, steam is emitted through the pad
│ GB │ MT
■ 46
/ . To facilitate the unwinding of the cable, you can flip down the
by pulling it out a little and turning it at the same time.
to "I". The on/off switch
flashes.
to select the desired level of steam generation:
. The appliance starts generating steam and,
on the steam foot
and flip the handle up-
on the rear of the handle so that the
lights up, the red
lights up.
lights up.
.
.
!
lights up.
SDM 1500 C2